Panasonic WJMP204 Betriebsanleitung PDF herunterladen (Seite 13)

COMMUNICATION

UNIT ADDRESS 1

BAUD RATE 9600

DATA BIT 8

PARITY CHECK NONE

STOP BIT 1

WAIT TIME OFF

(6) Wait Time Setting

1. Display the COMMUNICATION menu.

2. Move the cursor to WAIT TIME by pressing button 1

(OFF, 100, 200, 400, or 1000 ms) by pressing button 3

(–) or button 4 (+).

The initial factory setting is OFF (No retry).

(1) Unit Address Setting

1. Display the COMMUNICATION menu.

2. Move the cursor to UNIT ADDRESS by pressing button

1 (C) or button 2 (D), then select the desired unit

address in the range of 1 to 99 by pressing button 3 (–)

or button 4 (+).

Notes:

• Check before the above setting that the UNIT

switch is at 0. For address setting, see page 10.

• Before switching the Data Multiplex Unit back on,

remember that address setting with the UNIT

switch has priority to the above setting.

(2) Baud Rate Setting

1. Display the COMMUNICATION menu.

2. Move the cursor to BAUD RATE by pressing button 1

(19200, 9600, 4800, or 2400 bps) by pressing button 3

(–) or button 4 (+).

The initial factory setting is 9600bps.

(3) Data Bit Setting

Setting is fixed for 8 bit.

(4) Parity Check Setting

1. Display the COMMUNICATION menu.

2. Move the cursor to PARITY CHECK by pressing button

1 (C) or button 2 (D), then select the desired type of

parity check (NONE, EVEN or ODD) by pressing button

3 (–) or button 4 (+).

The initial factory setting is NONE.

(5) Stop Bit Setting

1. Display the COMMUNICATION menu.

2. Move the cursor to STOP BIT by pressing button 1 (C)

or button 2 (D), then select the desired number of stop

bits, 1 or 2 by pressing button 3 (–) or button 4 (+).

The initial factory setting is 1 bit.

■ System Setup for Panasonic

Security Data Mode

1. Display the Setup menu.

2. Move the cursor to SYSTEM by pressing button 1 (C)

or button 2 (D), then press the SUSPEND/SET button.

• In case of Panasonic Security Data mode, the SYS-

TEM menu appears as shown below.

SYSTEM

ALARM MODE ON

COMP/VD2/DATA

VS/VD INPUT VD

CAMERA CONFIG

DAISY MODE ON

TERMINAL ALARM

3. Move the cursor to the desired item by pressing button

1 (C) or button 2 (D), then then select the desired

mode by pressing button 3 (–) or button 4 (+).

4. Press the SUSPEND/SET button.

5. After taking the above steps, press the SETUP/ESC

button for 2 seconds or more.

Note: All the settings must be compatible with the

peripherals connected.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare

Panasonic WJMP204 Betriebsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitskameras Panasonic WJMP204