10
Address setting varies from one communication mode to another.
The setting should be made by qualified service personnel or system installers.
■ Panasonic Security Data Mode
Set each number as follows.
SETTING ADDRESSES
■ Camera Communication Mode
Set camera address as follows.
Notes:
• Do not set the UNIT switch to position 9 because it is a reserved number.
• When two Units corresponding to Panasonic Security Data or more are connected, check that each UNIT switch is set to a
number different from those of the others.
• In changing unit addresses using the setup menu, set the UNIT switch to position 0.
• Keep the power switch in the OFF position while setting unit numbers. Addresses cannot be set if power is on.
• For details of setting the System Controller WV-CU360, refer to the Operating Instruction for the System Controller.
Unit address
of WJ-MP204
UNIT Switch Settings of WJ-MP204
87654321
1
0
Set the
number in
Setup
menu
2345678
9
Prohibition
of a Setup
(reserved
number)
CAMERA
IN/OUT Connector
UNIT Switch Settings of WJ-MP204
8765432
1
1
2
3
4
0
Set the
number in
Setup
menu
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
9
Prohibition
of a Setup
(reserved
number)
Notes:
• Do not set the UNIT switch to position 9 because it is a reserved number.
• When two Units or more are connected, check that each UNIT switch is set to a number different from those of the others.
• In changing camera addresses using the setup menu, set the UNIT switch to position 0.
• Keep the power switch in the OFF position while setting unit numbers. Addresses cannot be set if power is on.
● Setting Unit Addresses
Turn the UNIT switch till the arrow points the desired number.
Kommentare zu diesen Handbüchern