Panasonic WV-SW314 Installationsanleitung PDF herunterladen (Seite 22)

v Connect a LAN cable (category 5e or better, straight, STP*) to the network connector.

* E model only

b Connect the power cable.

 • Whenusing12VDCpowersupply*

SW316L

SW316

Connect the output cable of the AC adaptor to the 2P power cable.

 • WhenusingPoE(IEEE802.3afcompliant)

Connect a LAN cable (category 5 or better, straight, STP*

) between a PoE device (such as a

hub) and the network connector of the camera.

*1 FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.

*2 E model only

IMPORTANT:

 • Useall4pairs(8pins)oftheLANcable.

 • Themaximumcablelengthis100m{328feet}.

 • MakesurethatthePoEdeviceinuseiscompliantwithIEEE802.3afstandard.

 • Whenconnectingboththe12VDCpowersupplyandthePoEdeviceforpowersupply,PoE

will be used for power supply.

 • WhentheLANcableisdisconnectedonce,reconnectthecableafterabout2seconds.When

the cable is quickly reconnected, the power may not be supplied from the PoE device.

c Connect the alarm input/output cable.

SW316L

SW316

Terminal name Ratings

ALARM OUT, AUX OUT Open collector output (maximum applied voltage: 20 V DC)

Open 4 V DC - 5 V DC by internal pull-up

Close Output voltage 1 V DC or less (50 mA or less)

ALARM IN, DAY/NIGHT IN

Non-voltage make contact input (4 V DC - 5 V DC, internally pulled

up)

OFF Open or 4 V DC - 5 V DC

ON Make contact with GND (required drive current: 1 mA or more)

Note:

 • Checkifratingofanexternaldevicesuchasasensorisapplicabletotheratingofthisproduct

by referring to the provided operating instructions.

Speciﬁcation of 4P alarm cable (accessory)

GND (black)

AUX OUT (gray) (Terminal 3)

ALARM OUT (red) (Terminal 2)

ALARM IN, DAY/NIGHT IN (green) (Terminal 1)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 49 50

Keine Kommentare

Panasonic WV-SW314 Installationsanleitung Seite 22