Panasonic WV-SW314 Installationsanleitung Seite 14

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 50
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 13
14
Precautions for installation
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Installthecamerainthefoundationareaof
the architecture or where sufficient strength
is assured.
• If a wall or ceiling board such as plaster
board is too weak to support the total
weight, the area shall be sufficiently rein-
forced.
Do not place this product in the following
places:
• Locationswhereachemicalagentisused
such as a swimming pool
• Locations subject to oil smoke such as a
kitchen
 • Locationsthathaveaspecificenvironment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations where corrosive gas is pro-
duced, locations where it may be damaged
by briny air such as seashores
• Locations where the temperature is not
within the specified range (page 43).
• Locationssubjecttovibrations(This prod-
uct is not designed for on-vehicle use.)
Be sure to remove this product if it is not
in use.
Design and engineer the power supply
system to turn on/off the power of this
product.
The product has no power switch. When
installing the product, use a power supply
device equipped with the ON-OFF switch for
servicing.
About the network connection
When connecting to a network using the network
cable of this product, observe the following.
• When wiring for the network, design and
engineer not to be affected by thunder.
• It is impossible to install this product in
combination with a pan/tilt head.
Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.
• Tightenscrewsatarightangletothesur-
face. After tightening screws, perform visu-
al check to ensure tightening is so suffi-
cient that there is no backlash.
The measures of protection against a fall
of this product shall be taken.
Failure to observe this may cause a drop resulting
in injury or accidents. Be sure to install the safety
wire.
Procure fixing screws separately.
The screws that secure this product are not
supplied. Prepare them according to the mate-
rial and strength of the area where the product
is to be installed.
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documenta-
tion.
Seitenansicht 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare