Panasonic TXP55VT50E Schnellstart Anleitung PDF herunterladen (Seite 22)

English

■ Registration again

When connection with registered TV fails, or when using with another TV, re-register the 3D Eyewear.

1 Turn the TV on

2 Within 50 cm from the TV, hold the power switch on the “MODE” position for more than 2 seconds

●

Release the power switch when registration starts.

3 The green LED lights for 3 seconds when the registration is successfully completed

Note

●

If the registration failed, the 3D Eyewear will be turned off. In this case, turn off the TV and perform from step 1.

Replacing the battery

When the battery is running low, the indicator lamp flashes 5 times on turning the 3D Eyewear on.

In this case, early battery replacement is recommended.

●

Dispose of the old batteries as non-burnable rubbish, or in line with the waste disposal regulations in your local area.

1 Loosen the screw and remove the cover using with a precision Phillips (No.0, plus +) screwdriver

●

The screw is not removed from the cover.

2 Replace the battery

●

If difficulty, remove it with the tip of the driver.

●

Use the specified type of battery (coin-shaped lithium

battery CR2025).

●

Note the correct polarity (+ or -).

3 Replace and fasten the cover

Push the cover firmly until it clicks.

Tighten the screw.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Keine Kommentare

Panasonic TXP55VT50E Schnellstart Anleitung Seite 22