Panasonic CZ-ESWC2 Installationshandbuch PDF herunterladen (Seite 28)

(5) Align the installation holes on the panel with the bolt

holes on the unit.

(6) Insert the supplied washer head bolts into the 4 panel

installation holes, and tighten until the panel is

securely fastened against the unit. (Fig. 3-77)

(7) Verify that the panel is securely fastened against the

unit.

At this time, make sure that there is no gap between

●

the indoor unit and the ceiling panel, or between the

ceiling panel and the ceiling surface. (Fig. 3-78)

If there is a gap between the ceiling panel and the

●

ceiling, leave the panel attached and adjust the

installation height of the indoor unit upwards until the

gap with the ceiling is eliminated. (Fig. 3-79)

If the adjustment is small enough that it will not affect

●

the levelness of the indoor unit or the drain piping, then

the unit height can be adjusted from the side panel

installation holes, with the ceiling panel still attached.

Indoor unit

Ceiling panel

Washer-head screw

Fig. 3-77

Insert a wrench or other

standard tool into the side

panel installation holes

and make fine adjustments

to the indoor unit nuts.

Fig. 3-79

Ceiling panel

Ceiling surface

Indoor unit

Must be no gap.

Fig. 3-78

Air leakage

Ceiling panel

air leakage

Stains

Condensation and water leakage

Adjust so that there is no gap.

CAUTION

If the screws are not fully tightened,

●

problems such as those shown below

may occur. Be sure to tighten the

screws securely.

If there is a gap between the ceiling

●

surface and the ceiling panel even when

the screws are fully tightened, readjust

the height of the indoor unit. (Fig. 3-79)

VRF_Indoor_US.indb 28VRF_Indoor_US.indb 28 2011/09/30 12:23:072011/09/30 12:23:07

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

Panasonic CZ-ESWC2 Installationshandbuch Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Panasonic CZ-ESWC2