Panasonic WV-CF300 Installationsanleitung PDF herunterladen (Seite 21)

Important:

• When shooting in the following place or following subjects, press the [SET] button again to

close the “FOCUS ADJUSTMENT” screen, or adjust to the best focus position while viewing

the image.

• Frequently moving subject

• Subject with large illuminance change

• Subject with low illuminance

• Too bright or reflective subject

• Subject through a window

• Place where the lens easily becomes dirty

• Subject with less contrast such as white wall

• Subject with remarkable depth

• Subject with heavy flicker

• Subject with horizontally parallel lines such as a shutter

1 Loosen the zoom knob and adjust to the best view angle between TELE and WIDE.

Note:

• The focus may not be adjusted smoothly when the zoom adjustment ring is extremely close to

the end of W direction (T direction). At this time, slightly adjust the zoom adjustment ring

towards the T direction (W direction), and then adjust the focus.

2 Tighten the zoom knob.

3 Rotate the front of the lens, and adjust to the best view angle between NEAR and FAR.

4 Press the [AF] button on the side of the camera, which will automatically focus.

Note:

• The AF function is not available over the entire focus range. Be sure to perform approxmate

adjustment of the view angle before manual focusing, and then press the [AF] button to enable

the AF function.

• For the following subjects, select ELC control method, and then manually adjust the focus.

• Fast-moving subject

• Subject with significant illuminance change

• Subject with low illuminance (such as high beam light)

• Too bright or reflective subject

• Subject behind a window

• Less contrasty subject (such as white wall)

• Subject with remarkable depth

• Subject with flicker

• Subject with parallel lines (such as a shutter)

• Blurred or dirty spherical cover

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Keine Kommentare

Panasonic WV-CF300 Installationsanleitung Seite 21