Panasonic WV-SW352 Installationsanleitung PDF herunterladen (Seite 24)

Heater Unit WV-SW3H (option)

 • Installing thisheater unitenables thecamera tooperate ina low-temperatureenvironmentof

–30 °C {–22 °F} or above. A small fan inside the unit will minimize condensation on the surface

of the enclosure caused by changes in ambient temperature unless temperatures change too

rapidly. The fan will stop when there is no possibility of condensation.

 • Theheaterunitisautomaticallyturnedonoroffaccordingtothetemperatureinsidethecamera

that is monitored.

Important:

 • Turningtheheateronandoffmaydisturbthecameraimages.

 • Thepowersupplyofthecamerashallbeturnedoffwhenmountingordismountingtheheater.

When servicing, pay attention to high temperature on the surface of the heater unit. Disconnect

the harness and wait until the heater unit cools.

 • Whenthisproductisinstalledandoperatedinlowtemperaturesbelow–10°C{14°F},normal

images may not be obtained immediately after startup. In such a case, wait until the camera is

warmed up (approx. 2 hours or more) and turn on the power again.

How to install the heater unit

q Detach the camera’s enclosure (☞ page 34) and mount it in the specified position with the

screw (accessory).

w Connect the harness cable to the heater unit connector of the camera.

Important:

 • Aftermountingtheheaterunit,arrangetheharnesscableasshownintheillustrationinstepe

so as not to be tangled round the enclosure, assist wire or equipment inside the camera.

How to install the heater unit

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Keine Kommentare

Panasonic WV-SW352 Installationsanleitung Seite 24