Panasonic WV-SF538 Installationsanleitung PDF herunterladen (Seite 26)

When using 12 V DC power supply*

q Loosen the screws of the power cord plug

(accessory).

w Connect the cable of the 12 V DC power sup-

ply* to the power cord plug.

Strip 3 mm - 7 mm {1/8 inches - 9/32 inches}

from the end of the wire, and twist the stripped

part of the wire sufficiently to avoid short circuit.

Specification of cable (wire):

16 AWG - 24 AWG, Single core, twisted

• Check whether the stripped part of the wire is

not exposed and is securely connected.

e Tighten the screws of the power cord plug.

(Recommended tightening torque: 0.34 N·m

{0.25 lbf·ft})

r Connect the power cord plug to the 12 V DC

power supply terminal.

* ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223)

or LIMITED POWER SOURCE (IEC/EN/UL/CSA 60950-1).

IMPORTANT:

• Be sure to use the power cord plug provided with this product.

• Be sure to fully insert the power cord plug (accessory) into the 12 V DC power supply terminal.

Otherwise, it may damage the camera or cause malfunction.

• When installing the camera, make sure that excessive force is not applied to the power cable.

• Be sure to use an AC adaptor compliant with the Specifications regarding power source and

power consumption. (☞ Page 40)

t Run the 12 V DC output cable through the gap of the cable hook.

12V=IN

12 V DC output cable

Cable hook

(12 V DC)

(GND)

Power cord plug

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Keine Kommentare

Panasonic WV-SF538 Installationsanleitung Seite 26