Panasonic WJ-HD616 Installationsanleitung PDF herunterladen (Seite 78)

Step 3

Set the end point of the detection area.

Press the [SET] button after moving the cursor to the desired

end point of the detection area using the arrows button (C

D A B). To finish the detection area setting, select the

[Back] button.

Note:

 • Detectionareaswillbesetaccordingtothegriddivided

in 16 x 14 segments. It may be possible that the actual

detection areas will not be exactly the same as the des-

ignated start and end points.

 • Todeleteasetdetectionarea,selectthe[Deletearea]

tab on the detection area setup page, and click the

[Delete] button of the area (A to D) to be deleted.

 • Whenusingamouse,clicktheendpoint.Upto4areas

can be set by repeating Step 1 to 3.

Step 4

Set the detection sensitivity for each detection area.

Move the cursor to the pull-down menu of "Sensitivity" of the

detection area to be set (A to D) using the arrows button (C

D A B). Then, rotate the JogDial (inside) to select the

detection sensitivity from the following.

Off: Ignores motion in the selected area.

Low: Low sensitivity

Mid: Standard sensitivity

High: High sensitivity

Step 5

Select the [Back] button after completing the settings.

→ The detection area setup page will be closed.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 155 156

Keine Kommentare

Panasonic WJ-HD616 Installationsanleitung Seite 78