Panasonic Attune Betriebsanleitung PDF herunterladen (Seite 20)

■ Wiring to the center modules

1. Remove the terminal cover.

Slide the front cover downwards by pressing its arrow-

marked part and pull the lower side of the cover toward

you.

2. Insert a “minus” screwdriver in the slot as illustrated and

remove the terminal socket from the main unit.

3. Connect the wiring material to the terminal socket.

Use the “minus” screwdriver and loosen the screw locat-

ed on the upper surface of the terminal socket.

Peel off the sheath from the tip of the wiring material and

insert the cable tip in the terminal socket.

Firmly tighten the loosened screw by means of the

“minus” screwdriver.

Repeat the above-mentioned same procedure for each

terminal.

Note: Process the wires according to the following.

Recommended wire type: AWG 28 - 16 (Do not use sol-

dered wires.)

Length to be stripped: 7 mm ± 1 mm {9/32" ± 1/16"}

Diameter of screw: ø 2 mm {3/32"}

Recommended tightening torque: 0.22 N·m to 0.25 N·m

4. Mount the cabled socket on the main unit.

Note: Insert the socket firmly into the main unit.

5. Slide the front cover from the bottom and mount it on the

main unit.

Note: Surely attach the front cover to the main unit.

INSTALL SYSTEM SETTING

OPER

ATI

ONAL SETTING

ID R

EGIST

ATI

EETE

TELEPHONE

CONTROL OUT

STA

ELAY

ECHO CA

DNR LEVEL

DUAL LANE

LANE SEL

ECT

POS REMOTE

TX POWE

RED MAX

YELLOW MD

GREEN LOW

OFF OFF

SEL

AUX

AUX IN

TALK

PAGE

BEEP

UTSIDE

TEAM

NIGHT

DAY

TSI

LEVEL

RRI

RELEASE

MIC

POS

CTO

SELE

ESTINATION

DSET

HEAD

SET

LAYB

7 mm ± 1 mm

{9/32" ±

1/16"}

Terminal socket