Panasonic EY6930 Bedienungsanleitung PDF herunterladen (Seite 6)

PARTIDENTIRCAT10N

(S) Keyless drill chuck

Note; When attaching or removing a

bit, be sure to set the reversing

lever to its center position

(switch lock).

This tool is equipped with a keyless

drill chuck.

1. Attachment

Insert the bit and turn the k>ck col

lar clockwise ( looking from the

front) to tighten firmly.

Slide the Lock collar to LOCK side.

Lock collar

2. Removal

Slide the Lock collar to FREE side.

Turn the lock collar counterclock

wise (looking from the front), then

remove the Ut. , ,

Lock collar

®FREE

Note: If the bit cannot be removed by

hand, insert the lock release

rod or a similar tool into the

hole located on the chuck to

release the lock, and then turn

the lock collar counterclock

wise (viewed from the front).

Chuck

(To prevent accidental operation,

remove the battery pack before trying

to remove the bit.)

Note; If excessive play occurs in the

chuck, (D secure the drill in place

and tighten the chuck by turning

clockwise, d) open the chuck

daws by unscrewing the lock col

lar and (d tighten the screw (left-

handed screw) with a screwdriver

by turning it counterclockwise

(viewed horn the front).

®

®i

Clutch Handle

(Clutch Torque Setting)

Adjust the torque to one of the 5 pos

sible settings to the job.

CAUTION: Test the setting before

actual operation.

Set the scale at this line

Reference for Adjusting Torque

Seal«

Torque

Use

1

Approx. 1.0 Nm

(10 kof-cm or 8.7 in-l».)

Rk driving

terminal screws

2

Approx. 1.5 Nm

(15 kgl-cm or 13.0 irt-IbB.)

For driving

machine screws

3

Approx, 2,6 Nm

(25 kgf-cm OT21.7 In-lbs.)

For driving Mrews

irttosoflfflUwlBls

4

Approx. 3.4 Nm

(35 kgf-cm or 30.4 in-lbs.)

For driving

5

Approx. 4.4 Nm

(45 kgf-cm or 38.0 tn-lbs.)

hardwood

qa

19.6 Nm 200kgf-cm,

173.4 in-Kw. (Low speed)

Forpoweiftjl

driving mddriHng

r

Percussion

For drWng to mor

tar, brick etc.

-6-

1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare