Panasonic EY6181 Bedienungsanleitung PDF herunterladen (Seite 4)

16) Do not charge battery pack when the

temperature is BELOW 32“F (0‘C) or

ABOVE 104T {40°C). This is very

important.

17) Do not incinerate the battery pack. It can

explode in a fire.

18) Avoid dangerous environment. Do not

use charger in damp or wet locations.

19) The charger is designed to operate on

standard household electrical power

only. Do not attempt to use it on any

other voltage!

20) Do not abuse cord. Never carry charger

by cord or yank it to disconnect from

outlet. Keep cord away from heat, oil and

sharp edges.

21) Charge the battery pack in a well

ventilated place, do not cover the

charger and battery pack with a cloth,

etc., while charging.

22) Use of an attachment not recommended

may result in a risk of fire, electric shock,

or injury to persons.

23) Do not short the battery pack, A battery

short can cause a large current flow,

over heating and burns.

24) NOTE: If the supply cord of this

appliance is damaged, it must only be

replaced by a repair shop appointed by

the manufacturer, because special

purpose tools are required.

ADDITIONAL

SAFETY RULES

1) Be aware that this tool is always in an

operating condition, since it does not have to

be plugged into an electrical outlet.

2) When drilling or driving into walls, floors,

etc., “live" electrical wires may be

encountered. DO NOT TOUCH THE CHUCK

OR ANY FRONT METAL PARTS OF THE

TOOL! Hold the tool only by the plastic

handle to prevent electric shock in case you

drill or drive into a “live” wire.

3) If the bit becomes jammed, immediately

turn the main switch off to prevent an

overload which can damage the battery pack

or motor. Use reverse motion to loosen

jammed bits.

4) Do not operate the reversing lever when

the main switch is on. The battery will

discharge rapidly and damage to the unit

may occur.

5) During charging, the charger may become

slightly warm. This is normal. Do not charge

the battery for a long period.

6) Use only a dry, soft cloth for wiping the

unit. Do not use a damp cloth, thinner,

benzine, or other volatile solvents for

cleaning.

7) When storing or carrying the toot, set the

reversing lever to the center (switch lock)

position.

8) Do not strain the tool by holding the speed

control trigger halfway (speed control mode)

so that the motor stops.

9) Do not operate the speed selector switch

(LOW-HIGH) while pulling on the speed

control trigger. This can cause the

rechargeable battery to wear quickly or

damage the internal mechanism of the

motor.

• Changes or modifications not expressly

approved by MATSUSHITA ELECTRIC

WORKS, LTD. could void the user’s

authority to operate the equipment.

1 2 3 4 5 6 7 8 9 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare