Panasonic TX49FS352B Betriebsanleitung PDF herunterladen (Seite 7)

English - 6 -



If the TV does not receive any input signal (e.g. from

an aerial or HDMI source) for 3 minutes, it will go

into standby. When you next switch-on, the following

message will be displayed: “TV switched to stand-by

mode automatically because there was no signal

for a long time.” Press OK to continue.

If the TV is on and it isn’t being operated for a while

it will go into standby. When you next switch-on, the

following message will be displayed. “TV switched to

stand-by mode automatically because no operation

was made for a long time.” Press OK to continue.

TV Control & Operation

P+

V+

V-

P-

Note:         

the model.

The joystick allows you to control the Volume /

Programme / Source and Standby-On functions of

the TV.

To change volume: Increase the volume by pushing

the joystick right. Decrease the volume by pushing

the joystick left.

To change channel: Scroll through the stored

channels by pushing the joystick up or down.

To change source: Press the centre of the joystick

in, the sources list will appear on the screen. Scroll

through the available sources by pushing the joystick

up or down.

 Press the centre of the joystick in

and hold it down for a few seconds, the TV will turn

into standby mode.

To turn on the TV: Press the centre of the joystick in,

the TV will turn on.

Note: Main menu OSD cannot be displayed via joystick.

Operation with the Remote Control

Press Menu button on your remote control to display

main menu screen. Use the directional buttons to select

a menu tab and press OK to enter. Use the directional

buttons again to select or set an item. Press Return/

Back button or Menu button to quit a menu screen.

Input Selection

Once you have connected external systems to your

 

Source button on your remote control consecutively



Changing Channels and Volume

You can change the channel and adjust the volume

by using the Volume +/- and Programme +/- buttons

on the remote.

Inserting the Batteries into the Remote

Remove the back cover to reveal the battery

compartment. Insert two size AA batteries. Make sure

the (+) and (-) signs match (observe correct polarity).

Do not mix old and new batteries. Replace only with

same or equivalent type. Place the cover back on.

Connect Power

IMPORTANT: The TV set is designed to operate on

220-240V AC, 50 Hz socket. After unpacking, allow the

TV set to reach the ambient room temperature before

you connect the set to the mains. Plug the power cable

to the mains socket outlet.

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL

INPUT (ANT) socket located on the back of the TV.

1 2 3 4 5 6 7 8 9 10 11 12 ... 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare

Panasonic TX49FS352B Betriebsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für LCD-Fernseher Panasonic TX49FS352B