
- 89 -
http://panasonic.net/viera/support (English only)
= Note =
●
This function is not available when the TV is turned off with Mains Power
On / Off switch.
●
Depending on the network condition, this function may not be available.
Note
●
TV Guide may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming, the TV must be either on or in
Standby. For reminders to be displayed, the TV must be on.
●
No other channels can be selected while the recording of Timer
Programming is in progress.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the start time, a reminder message appears if you are
watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
●
LED will turn to orange in Standby mode if Timer Programming is set.
●
Reminder messages will remain displayed until one of the following
occurs:
– You press OK to view the programme or EXIT to cancel the reminder.
– The timer event that the reminder is set for ends.
●
“!” identifies that two or more timer events are overlapped. USB HDD Rec.
is given priority over Reminder. As for the overlapped recording events,
the first event starts and finishes as programmed. The next event can then
start.
●
The recording of Timer Programming will automatically change the
channel to the programmed channel a few seconds before the start time.
●
The recording of Timer Programming will be performed even if the TV is
in REW LIVE TV recording. In this case, REW LIVE TV recording will be
cancelled.
Recording > Recording current programme > REW LIVE TV
●
For more information of the USB HDD
Recording > Technical information
Kommentare zu diesen Handbüchern