
9
Precautions
Do not operate this product beyond its specified tem-
perature, humidity, or power source ratings.
Use this product at temperatures between 5 °C to 45 °C
{41 °F to 113 °F} and where the humidity is between 5 % to 90
%.
The input power source for the NTSC model is 120 V AC 60
Hz, and for the PAL model is 220 V to 240 V AC 50 Hz.
Performance and lifetime of hard disk drives are easily affected
by heat (used at high temperature).
It is recommended to use this product at temperatures
between 20 °C to 30 °C {68 °F to 86 °F}.
POWER switch
The POWER switch is located at the rear of this product. Even
though the POWER switch is set to "OFF", the power supply
will not be cut. To cut the power supply, remove the power
plug of this product from the AC outlet. When using the power
supply control unit, turn off the power of the power supply
control unit.
Built-in backup battery
• Beforethefirstuse,chargethebuilt-inbackupbattery(lith-
ium battery) by turning on the power for 48 hours or more.
If it is not charged enough, in a case where the power
goes down, the internal clock may keep bad time or the
operative condition may be different to that before the
electric power failure.
• Thebuilt-inbatterylifeisapproximately5yearsasanindi-
cation of replacement. This is just an indication of replace-
ment. We are not providing any guarantee of the built-in
battery lifetime. Replacement cost of the built-in battery is
not covered by the warranty even if it needs to be done
within the warranty period.
• Asktheshopwhereyoupurchasedthisproductwhen
replacement of the battery is required.
Hard disk drive (HDD)
• Harddiskdrivesarevulnerabletovibration.Handlethem
with care.
It is possible to damage them if they are moved while their
motors are still running.
• Donotmovethemjustafterturningthepoweroff(for
around 30 seconds).
• Thelifetimeofharddiskdrivesislimitedbyuse.Write
errors may occur frequently after around 20 000 hours of
operation, and the head and motor deterioration may
occur after 30 000 hours of operation. They will reach the
end of their lifetime after 30 000 hours of operation if they
have been used at the recommended ambient tempera-
ture (approx. 25 °C {77 °F}).
• Itisrecommendedtoreplacethemafteraround18000
hours of operation to prevent data loss from disk failures.
• Whenharddiskdrivetroubleoccurs,replaceitimmediate-
ly.
Contact your dealer about servicing.
When replacing the hard disk drives, take notice of the
following.
• Protecttheharddiskdrivesfromstaticelectricity.
• Donotstackthem,orkeepthemupright.
• Donotuseanelectricscrewdrivertofixthem.
(Tightening torque: Approx. 0.49 N·m {5 kgf·cm})
• Avoidrapidchangesofthetemperature/humiditytopre-
vent condensation.
(Acceptable change: within 15 °C/h {59 °F/h})
• Recordedimagesontheharddiskdrivesmaycontainper-
sonal information. Please be forewarned that we don't
recover or dispose of the hard disk drives.
• Pleasebeforewarnedthatanylossofinformation,suchas
images, on the hard disk drives is not guaranteed under
any circumstances.
Prevent condensation from forming on the surface of the
hard disk drive.
If this happens, do not turn on the power of this product.
Instead leave it switched off for around 2 hours.
Wait until the dew evaporates in any of the following cases:
• Thisproductisplacedinanextremelyhumidplace.
• Thisproductisplacedinaroomwhereaheaterhasjust
been turned on.
• Thisproductismovedfromanair-conditionedroomtoa
humid or high-temperature room.
When this product has not been used for a certain peri-
od, turn on the power (approximately once a week), and
perform recording/playback to prevent interferences
with functions.
Cleaning
• Turnthepoweroffwhencleaningthisproduct.Otherwiseit
may cause injuries.
• Donotusestrongorabrasivedetergentswhencleaning
the body. Use a dry cloth to clean this product when it is
dirty.
• Whenthedirtishardtoremove,useamilddetergentand
wipe gently.
• Whenusingachemicalclothforcleaning,readthecaution
provided with the chemical cloth product.
Product disposal/transfer
Data saved on the hard disk drive may lead to personal infor-
mation leakage. When it is necessary to dispose of or give this
product to someone, even when for repair, make sure that
there is no data on the hard disk drives.
Indication label
Refer to the indication label placed on the surface of this prod-
uct as to the indications of equipment classification and power
source, etc.
Kommentare zu diesen Handbüchern