Panasonic WJ-ND300 Bedienungsanleitung PDF herunterladen (Seite 3)

WJ-ND300 SATA conversion guide (RAID)

Maintenance guide

Panasonic

ND300_SATAConversionGuideR_A

3. Replacement Procedure

Important +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

• Power off the unit and disconnect from the mains power supply before carrying out this work.

• Do not detach the cable connecting the unit and the front panel while the HDD status indicators are still lit or until 30 seconds have

passed since the HDD status indicators went off.

• Protect the hard disk drives from static electricity.

• Do not stack them, or keep them upright.

• Do not use an electric screwdriver to x them. (Tightening torque: Approx. 0.49 N · m (5 kgf · cm))

• Avoid rapid changes in the temperature/humidity to prevent condensation. (Acceptable change: within 15°C/h (59 °F/h))

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

(1) Open the connectors cover on the front panel and remove the

xing screw.

Detach the front panel by sliding it after removing the screw.

(2) Disconnect the connector from the front panel.

(3) Disconnect four ATA cables and four HDD power cables

of all HDDs.

Note:

When disconnecting the ATA cables, pull the pull-ring

slowly and straightforward.

OPERATE

SUS

DED

ERRO

IME

LINK

HDD

J-N

300

Connectorscover

Screw

Front panel

connector

Front panel

connector

Pull-ring

1 2 3 4 5 6 7 8 ... 14 15

Keine Kommentare

Panasonic WJ-ND300 Bedienungsanleitung Seite 3