Panasonic WJ-HDE300 Bedienerhandbuch

Extension UnitInstructionsModel No. WJ-HDE300/GWJ-HDE300Extension UnitBefore attempting to connect or operate this product,please read these instructi

102-2 Slide the front cover to the left.2-3 Pull the front cover toward you.2-4 Disconnect the harness.2-5 Remove the six screws (marked with ∆) and d

117. Place the brackets with the fixed HDDs into the unit andfix them using the four screws removed in step 3.• Do not use an electric screwdriver to

12 Mounting in a Rack ● Unit LayoutNotes:• Be sure to make a space of 1 U (44 mm) between theunits for ventilation in a rack.• Refer to “● Unit Numbe

13● How to Mount1. Turn off the power of the unit and detach the plug fromthe outlet.When not turning off the power, open the front coverand turn off

14INOUTCASCAKEOUT1616415151414132113121211111010998877665544332211CAMERAAUDIO IN AUDIO OUTMONITOR OUT CASCADE INMONITOR (VGA) ALARM/CONTOROLSERIAL ALA

15● Basic SetupsSetup to the SINGLE modePerform the following to set up the unit to the SINGLE modefor the first time.1 Power OFFConfirm that the powe

16Setup to the RAID5 modePerform the following to set up the unit to the RAID5 modefor the first time.1 Power OFFConfirm that the power of the recorde

17Formatting (Initialization) the hard diskIt is necessary to initialize the hard disk in the followingcases. When replacing or adding the hard diskWh

18● Initializing selected hard disk (the selected unitwhen using the RAID5 mode)• Select "SELECTED DISK" for the SINGLE mode or "ONEUNI

19● Replacement & Setup in theSINGLE modeWhen the drive has become faulty in the SINGLE mode,perform replacement and setup as shown below.1 SAFETY

2The serial number of this product may be found on the rearof the unit.You should note the serial number of this unit in the spaceprovided and retain

20● Changing SetupsChanging the total number of HDD inRAID5Do the following when the total number of the harddisks in the extension unit is increased

21Changing hard disk modeDo the following when the hard disk mode is changedfrom SINGLE to RAID5 or vice versa after the systemhas been operated. Skip

22● Recovery of RAID5 DiskReplacing and recovering RAID5 disk When an HDD access indicator on the front panel of theextension unit is lit red, it indi

234 HDD SAFETY MODE OFF• Select OFF on the HDD SAFETY MODE window andpress the SET button.→ The recorder will restart and enter the systemcheck mode.

24Setting/Changing hard disk mode afterresetting errorIt is impossible to change or set up the hard disk modewhen the ERROR indicator and one of HDD a

254 MODE switch settingSet the MODE switch to SINGLE or RAID5.5 SAFETY MODE OFF• Select OFF and press the SET button.→ The recorder will restart. Aft

26● Unit Number CheckHow to check the unit numberEach extension unit is given a unit number dependingon the connected position. Refer to Connections

27Symptom TroubleshootingCauseNo power is supplied. Insufficient power cord connectionPOWER switch or HDD POWER switch isturned off.ERROR indicator l

28 SpecificationsRequired power: 220 V AC - 240 V AC 50 HzPower consumption: 85 W (including 4 HDDs when installed)Interface: 2-wire serial, 480 Mbps

3 Important Safety Instructions1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all instructions.5) Do not use th

[English]Declaration of Conformity with the requirements of Technical Regulation on the Restriction Of the use of certainHazardous Substances in Elect

http://panasonic.netImporter's name and address to follow EU rules:Panasonic Testing CentrePanasonic Marketing Europe GmbHWinsbergring 15, 22525

4Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General . . . . . . . . . . . . . . . .

5 Precautions• Do not operate the appliance beyond its specified tem-perature, humidity or power source ratings. Do not use the appliance in an extre

6 Appearance● Front Viewq Error indicator [ERROR]Lights when an error occurs. Refer to Troubleshootingfor details.Red: System errorOrange: Thermal er

7POWERAC INSIGNAL GND12IN OUTEXTyu i io!0!1!2● Rear Viewy Serial in connector [IN]Connect the WJ-HD300 series digital disk recorder orother extension

8!3!4!5!6SINGLE RAID5MODERESETHDD POWERRECOVEROFF ONw’e’q’● Inside the Front Lidq' Error indicatorsFunctions the same as on the fro

9 Replacing/Mounting HDDsUp to four HDDs (locally procured) can be installed in anextension unit.Important• Type of hard disk driveConsult your deale