Panasonic PTAT5000E Betriebsanleitung PDF herunterladen (Seite 49)

[PICTURE] menu

ENGLISH - 49

Adjustment and

Settings

■

[MPEG NR]

You can eliminate the noise that occurs upon projection for

videos that use MPEG compression.

Weaken Strengthen

Setting range: 0 to +3

Attention

Use a strong setting when projecting an MPEG video.

COMPUTER (RGB) signal is not supported.

■

[FRAME CREATION]

You can activate the rendering system for fast motion

frames with fewer afterimage.

Switch settings Switch settings

[OFF] [MODE1]

[MODE3] [MODE2]

[OFF] Deactivate

[MODE1] Setting for a standard image

[MODE2] Setting for a cinema image

[MODE3] Setting for a fast moving image

Note

With some of the images, it might be difcult to see a

difference in result.

If [FRAME CREATION] is set to active, video may be

delayed in some cases. In this case, select [OFF].

This cannot be set to active when [2D TO 3D]

(



page 66) is enabled.

■

[COLOUR MANAGEMENT]

For the selected [PICTURE MODE], you can adjust a

selected colour individually with [CURSOR] mode or adjust

the six colour components (Red, Green, Blue, Cyan,

Magenta, Yellow) with [RGBCMY] mode.

Adjustment results can be saved as a prole and called

later.

●

Create a new prole

Note

[COLOUR MANAGEMENT] will be unable to adjust with

the setting of [REC709] in [PICTURE MODE], when

HDMI signal is selected.

When the input signal is switched while adjusting,

adjustment details are not saved.

If there is another area, which has the exact same or

similar colour as the target on the same screen, these

colours will be adjusted as well.

You can adjust all colours except white, gray and black.

If you edit a single colour to be individual different

colours, the desired colour may not be achieved.

When a 3D signal is being input (including converting 2D

to 3D), [COLOUR MANAGEMENT] cannot be executed.

Adjusting the selected colour (when

[CURSOR] is selected for [ADJUSTMENT

MODE])

Select the desired colour with a cursor and adjust.

Press the ◄► buttons to select [CURSOR] 1)

in [ADJUSTMENT MODE].

COLOUR MANAGEMENT

PROFILE

ADJUSTMENT MODE

START ADJUSTMENT

LOG

NORMAL

CURSOR

Press the ▲▼ buttons to select [START 2)

ADJUSTMENT] and press the <ENTER>

button.

The cross cursor

(A) is displayed, and the

projected image is captured.

Screen

Move the cursor with the ▲▼◄► buttons 3)

to the required place to select a colour.

Align the centre of the cross cursor on the point

in the projected image to be adjusted.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 103 104

Kommentare zu diesen Handbüchern

Keine Kommentare

Panasonic PTAT5000E Betriebsanleitung Seite 49

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Datenprojektoren Panasonic PTAT5000E