Operating InstructionsDigital Cordless PhoneModel No.KX-TGC210FXKX-TGC212FX Digital Cordless Answering SystemModel No.KX-TGC220FX Model shown is KX-
Setting upConnectionsn Base unitConnect the AC adaptor to the unit bypressing the plug firmly.Fasten the cord by hooking it.Connect the AC adaptor to
Battery chargingCharge for about 7 hours.R Confirm “Charging” is displayed (1).R When the batteries are fully charged,“Fully charged” is displayed.11N
ControlsHandsetABACJKHBGADEFISpeakerM N (Talk)Dial keypadMZN (Speakerphone)MicrophoneReceiverDisplayM N (Off/Power)MR/ECONR: Recall/FlashECO: Eco mode
M N (Locator)R You can locate a misplaced handsetby pressing MN.n KX-TGC220 series: page 3AEBCDFGHICharge contactsSpeakerMjN/MkN (: Volume up/down)M N
*1 KX-TGC212*2 Caller ID subscribers only*3 KX-TGC220 series: page 3*4 Voice mail subscribers onlyHandset soft key iconsIcon ActionReturns to the prev
3 Record a greeting message. a MnN aMNOther settingsOne touch eco modeWhen the handset is on the base unit, thebase unit transmission power is reduced
Making calls1 Lift the handset and dial the phonenumber.R To correct a digit, press MCN.2 MN 3 When you finish talking, press MN orplace the handset o
3 To release hold, press MN.Note:R After holding for 10 minutes, the call isdisconnected.Mute1 Press MN during a call.2 To return to the call, press M
IntercomAvailable for:KX-TGC212Intercom calls can be made betweenhandsets.Note:R When paging the handset, the pagedhandset beeps for 1 minute.R If you
PhonebookYou can add 50 names (16 characters max.)and phone numbers (24 digits max.) to thephonebook.Important:R All entries can be shared by any regi
IntroductionModel composition ...3Accessory information ...3General information ...
PIN that you have stored in the phonebook,without having to dial manually.1 During an outside call, press MN.2 MbN: “Phonebook” a MOKN3 MbN: Select th
Menu listTo access the features, there are 2 methods.n Scrolling through the display menus1 MN2 Press MCN, MDN, MEN, or MFN to select the desired main
Sub-menu 1 Sub-menu 2 Settings CodeAnswer On*2– – #327 31Answer Off*2– – #328 31Main menu: “Time Settings”Sub-menu 1 Sub-menu 2 Settings CodeSet Dat
Sub-menu 1 Sub-menu 2 Settings CodeSpeed Dial– – #261 20Eco Setup TransmissionPower*2<Normal>Low#725 15Display Setup Backlight<On>Off#276
Main menu: “Caller List”Operation CodeViewing the caller list. #213 29Main menu: “Ringer Setup”Sub-menu 1 Sub-menu 2 Settings CodeRinger Volume Ha
*12 The default setting will be as follows if you select the following regional codes whenchanging the unit’s region setting (page 27):“Česká rep.” =
When a call is received, the unit does not ringwhile the caller is being identified. If thecaller’s phone number matches an entry in thecall block lis
handsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “No”. If you select“Yes” without ente
Setting the repeater mode1 M N#1382 MbN: Select the desired setting. a MOKNa M NRegistering the DECT repeater(KX-A405) to the base unitNote:R Please u
Using Caller ID serviceImportant:R This unit is Caller ID compatible. To useCaller ID features, you must subscribe to aCaller ID service. Contact your
Model compositionn KX-TGC210 series n KX-TGC220 seriesR Model shown is KX-TGC210. R Model shown is KX-TGC220.Series Model No.Base unit HandsetPart No.
Erasing all caller information1 M N2 M N a MbN: “Yes” a MOKN a MN30Caller ID ServiceTGC210_212_220FX_(en-en)_140714_ver.110.pdf 30 2014/07/15 10:5
Answering systemAvailable for:KX-TGC220 series (page 3)The answering system can answer and recordcalls for you when you are unavailable toanswer the p
pre-recorded greeting asking callers toleave a message.– If the message recording time (page 35)is set to “Greeting Only”, callers’messages are not re
Key Operation0 Turn answering system off*4*3Erase currently playingmessage*5 Erase all messages*6 Reset to a pre-recordedgreeting message*1 If pressed
Key Operation*5 Erase all messages*6 Reset to a pre-recordedgreeting message (duringgreeting message playback)*# End remote operation(or hang up)*1 If
so, contact your service provider/telephone company.Caller’s recording timeYou can change the maximum messagerecording time allowed for each caller. T
Voice mail serviceVoice mail is an automatic answering service offered by your service provider/telephonecompany. After you subscribe to this service,
Alphabet character table (ABC)zy12 3 4 5 6 7 8 9Numeric entry table (0-9)zy1234 5 6 7 8 9Greek character table ( )z y12 3 4 5 6 7 8 9Extended 1 charac
R The following are used for both uppercase and lowercase:Cyrillic character table ( )zy12 3 4 5 6 7 8 9Error messagesDisplay message Cause/solutionBa
General useProblem Cause/solutionThe handset does not turnon even after installingcharged batteries.R Place the handset on the base unit or charger to
A B C D E FAdditional/replacement accessoriesPlease contact your nearest Panasonic dealer for sales information.Accessory item Model numberRechargeabl
Problem Cause/solutionI fully charged thebatteries, but– still flashes or–the operating timeseems to be shorter.R Clean the battery ends ( , ) and th
Problem Cause/solutionCaller information is slowto display.R Depending on your service provider/telephone company, theunit may display the caller’s in
Registering a handset to the base unit1 Handset:MN#1302 Base unit:Press and hold MN for about 5 seconds.R If all registered handsets start ringing, pr
IndexA Alarm: 25Answering calls: 16Answering system: 31Call screening: 34Erasing messages: 32, 33Greeting message: 31Greeting only: 35Listening
N CzechN SlovakiaB-dul Preciziei, Nr. 24, West Gate Park, Clădirea H3, Etaj 2, Sector 6, București, 062204, Romania Telefon: +40.21.316.31.61F
For your future referenceWe recommend keeping a record of the following information to assist with any repair underwarranty.Serial No. Date of purch
For your safetyTo prevent severe injury and loss of life/property, read this section carefully beforeusing the product to ensure proper and safeoperat
R This product is unable to make calls when:– the handset batteries need recharging orhave failed.– there is a power failure.– the key lock feature is
should not be placed in rooms where thetemperature is less than 0 °C or greaterthan 40 °C. Damp basements should alsobe avoided.R The maximum calling
SpecificationsR Standard:DECT (Digital Enhanced CordlessTelecommunications),GAP (Generic Access Profile)R Frequency range:1.88 GHz to 1.90 GHzR RF tra
Kommentare zu diesen Handbüchern