Panasonic WJSX550_SERIES Betriebsanleitung PDF herunterladen

Pin No. Designation

-1-

Video Output Board

WV-PB5504AE

Before attempting to connect or operate this product, please read these instructions completely

PREFACE

The WV-PB5504AE Video Output Board is provided for expanding the video output capability of the

Matrix Switcher.

APPEARANCE

1. Alarm Output/Reset Output Connector (ALARM OUT/RESET OUT)

External Timing Input Connector (EXT TIMING IN)

Recover Input Connector (RECOVER IN)

ALARM OUT: When the Matrix Switcher receives an alarm from the WV-PB5564E Alarm Board

or camera site receivers WV-RC100, WV-RC150 or WV-RC170, the alarm output signal is

provided at this connector for the Time Lapse VTR. The active pin number of the alarm out-

put depends on the alarm mode set by the on-screen programme (Mode-1, Mode-2,

Mode-3).

RESET OUT: When the Matrix Switcher resets the activated alarm, the alarm reset output sig-

nal, either Open Collector or pulse, is provided at this connector for the Time Lapse VTR.

EXT TIMING IN: The camera switching interval (Sequential Dwell Time) can be synchronized

with the lapse mode set in the Time Lapse VTR.

EXT. TIMING IN 1 controls Monitor 1 output, EXT. TIMING IN 2 controls Monitor 2 output, etc.

Supply the camera switching pulse from the Time Lapse VTR to this connector. Minimum

duration for camera switching pulse needs to be more than one (1) second.

RECOVER IN: This connector accepts the alarm recover signal from the Time Lapse VTR.

When handling this board, hold only by circuit board edges. Otherwise components on the

board may be damaged by static electricity.

Caution

ALARM OUT 1

RESET OUT 1

RECOVER IN 1

Ground

EXT TIMING IN 1

Ground

ALARM OUT 2

RESET OUT 2

RECOVER IN 2

Ground

EXT TIMING IN 2

(+5V DC)

ALARM OUT 3

RESET OUT 3

RECOVER IN 3

Ground

EXT TIMING IN 3

Ground

ALARM OUT 4

RESET OUT 4

RECOVER IN 4

Ground

EXT TIMING IN 4

Ground

OUT

MONITOR

ALARM OUT

RESET OUT

EXT TIMING IN

RECOVER IN

OUTPUT

1 2 3 4

Inhaltsverzeichnis

Seite 1 - WV-PB5504AE

Pin No. Designation-1-Video Output BoardWV-PB5504AEBefore attempting to connect or operate this product, please read these instructions completelyPREF

Seite 2 - BOARD SETTING

BOARDNO.-2-BOARD SETTINGBefore installing this board, the following settings should be made by qualified service personnel or system installers.1. Set

Seite 3 - NOR REV NOR REV

PAL TESTNORSW6NTSCOFF12These switches are used only for factory test.Always keep these switches in the positions as shown on the right in thefield.Not

Seite 4 - SPECIFICATIONS

4. Make sure to push in the Video Output Board until it isseated firmly.5. Secure the Video Output Board by tightening the twoscrews on the board.6. C