Panasonic TX40FSR500 Betriebsanleitung PDF herunterladen (Seite 97)

2) Set Satellite for the selected LNB.

– Select No Satellite if you do not know the connected satellite.

(Available satellite is searched in Auto Setup.)

– Select User defined to set Test Transponder Frequency manually.

– If you set to Single Cable, additional settings are required. Set

SingleCable Version, User Band, User Band Frequency and PIN

(depending on the Single Cable router you use). For details, read

the manual of the Single Cable router.

Watching > Tuning and editing channels > Selectable satellites

5. Press BACK/RETURN to store.

6. Select Auto Setup and press OK to access.

7. Select Search Mode / Scan Mode and press OK to access.

8. Set the item and press OK to store.

●

Scan Mode

Quick:

Scans the suitable frequency for the selected satellite.

Full:

Scans the whole frequency range.

●

After settings, select Start scan and press OK to search.

9. A confirmation screen is displayed and press OK to start Auto Setup.

(Settings are made automatically.)

●

When the operation is completed, the channel at the lowest position will

be displayed.

■ DVB-C, DVB-T, Analogue

1. Select Auto Setup and press OK to access.

2. Set DVB-C Auto Setup Settings and press OK to store. (DVB-C)

●

Scan Mode

Quick:

Scans the suitable frequency in your country.

Full:

Scans the whole frequency range.

●

Normally set Frequency, Symbol Rate and Network ID to Auto. If Auto

is not displayed or if necessary, enter each value specified by your

cable provider with Numeric buttons.

- 97 -

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 293 294

Keine Kommentare

Panasonic TX40FSR500 Betriebsanleitung Seite 97