Panasonic SC-BTT290 Betriebsanleitung PDF herunterladen (Seite 46)

VQT3Z96

It is possible to shorten the height of the front

speaker by directly connecting the speaker to the

base without using the stand.

Preparation

Detach the speaker cable from the stand.

1 Thread the detached cable through the

base.

2 Attach the speaker to the base and tighten

the screw (supplied) securely.

3 Connect the speaker cable to the speaker

and to the terminal of the main unit. (> 14)

∫ Reattaching the speaker cable

to the stand

Reference

Troubleshooting guide

Before requesting service, please perform the

following checks.

If the problem remains unresolved, consult

your dealer for instructions.

The following do not indicate a problem with

this unit:

– Regular disc rotating sounds.

– Image disturbance during search.

– Image disturbance when replacing 3D discs.

∫ Unit doesn’t respond to remote

control or front panel buttons.

Press and hold [

/I] on the main unit for 3 seconds.

– If still unable to turn the unit off, disconnect the

AC mains lead, wait 1 minute, then reconnect

the AC mains lead.

∫ Cannot eject disc.

The unit may have a problem.

While the unit is off, press and hold [OK], the

yellow button and the blue button on the remote

control at the same time for more than 5 seconds.

j“00 RET” is displayed on the unit’s display.

2 Repeatedly press [1] (right) on the remote

control or [Í/I] on the unit until “06 FTO” is

displayed on the unit’s display.

3 Press [OK] on the remote control or

[< OPEN/CLOSE] on the unit.

To return to the factory preset.

¾ Select “Yes” in “Default Settings” in the Setup

menu. (> 42)

To return all settings to the factory preset.

¾ Reset the unit as follows:

While the unit is off, press and hold [OK], the

yellow button and the blue button on the remote

control at the same time for more than 5 seconds.

j“00 RET” is displayed on the unit’s display.

2 Repeatedly press [1] (right) on the remote

control or [Í/I] on the unit until “08 FIN” is

displayed on the unit’s display.

3 Press and hold [OK] on the remote control or

[< OPEN/CLOSE] on the unit for at least

3 seconds.

[BTT490]

Front speaker assembly option

Straighten the

cable and run

through the stand.

Pull out the

cable through

the hole.

Do you have the latest firmware installed?

Firmware updates may be released to correct

operating irregularities that are discovered with

certain movies. (> 21)

General operation

SC-BTT590&490&290EB-VQT3Z96_mst.book 46 ページ２０１２年１月１２日　木曜日　午前９時４０分

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Panasonic SC-BTT290 Betriebsanleitung Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Heimkinosysteme Panasonic SC-BTT290