Panasonic PT-F200 Bedienungsanleitung PDF herunterladen (Seite 35)

OPTION menu

ENGLISH - 35

Settings

You can set the off timer to switch off the POWER of the

projector after a certain period of time automatically

when no signal is detected. Press I H to select the

required period from 15 to 60 minutes at intervals of

5 minutes.

You can switch the projector start up status for when the

Mains lead is connected while the MAIN POWER is on,

or for when the MAIN POWER is switched on while the

Mains lead is connected. Press I H to select the

required option.

OFF The projector will start from the

standby mode or the projecting

mode.

ON The projector will start from the

projecting mode.

You can turn off the function of the control panel buttons

on the projector body. Press I H to select the required

option.

INVALID Invalidate the control panel buttons

Confirmation screen will be

displayed.

VALID Validate the control panel buttons

You can turn off the AUTO SETUP function for when the

COMPUTER signal is detected.

AUTO When the projector detect a

COMPUTER signal, adjust the

projected image position

automatically for SIGNAL SEARCH,

DOT CLOCK and CLOCK PHASE.

BUTTON Only when the AUTO SETUP button

is pressed, the projected image

position will be adjusted for DOT

CLOCK and CLOCK PHASE. See

“Remote control” on page 11.

You can turn off the auto signal detecting system.

ON Detect the input signal from the

terminals and project the image.

OFF Deactive

When installing the projector, select the projection

method according to the projector position. Press I H

to cycle through the options. See “Projection method” on

page 15.

If you use the projector at high elevation, the ALTITUDE

setting need to be HIGH to set the fan speed high. Press

I H to select the required option.

LOW The fan speed is low.

HIGH The fan speed is high.

POWER OFF TIMER

DIRECT POWER ON

NOTE:

• When the projector is started from the projecting mode,

pressing the POWER button procedure is skippable.

CONTROL PANEL

DISABLE

15 MIN.

20 MIN.

25 MIN.

30 MIN.

35 MIN.

60 MIN.

55 MIN.

50 MIN.

45 MIN.

40 MIN.

AUTO SETUP

NOTE:

• Usually the recommended setting is AUTO.

SIGNAL SEARCH

NOTE:

• SIGNAL SEARCH is not available when any input

signal is projecting.

• Usually the recommended setting is ON.

INSTALLATION

FRONT/DESK

Setting on a desk/floor and

projecting from front

FRONT/CEILING

Mounting in the ceiling and

projecting from front

REAR/DESK

Setting on a desk/floor and

projecting from rear

REAR/CEILING

Mounting in the ceiling and

projecting from rear

ALTITUDE

NOTE:

• At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the

setting must be HIGH.

• The loudness of fan noise depends on the ALTITUDE

setting.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

Panasonic PT-F200 Bedienungsanleitung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Datenprojektoren Panasonic PT-F200