Panasonic SCEN7 Bedienungsanleitung PDF herunterladen

Dear customer

Thank you for purchasing this product.

Before connecting, operating or adjusting this product, please read these

instructions completely.

Please keep this manual for future reference.

These instructions are applicable to the following systems.

“EB” on the packaging indicates the United Kingdom.

Display

System SC-EN7

Main unit SA-EN7

Speakers SB-EN7

Operating Instructions

CD Stereo System

Model No. SC-EN7

Note

Troubleshooting guide

Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, consult your

dealer for instructions.

No play.

• The disc isn’t correctly set.

• The disc is scratched or dirty. (Tracks skipped.)

• There is moisture on the lens. Wait for about an hour

and then try again.

MP3 cannot be read.

• You may not be able to play MP3 if you have copied a

multi-session disc that has no data between sessions.

• When creating a multi session disc, it is necessary to

close the session.

• The amount of data on the disc is too small. Set the

amount of data to greater than approximately 5 MB.

Sound is unfixed,

reversed or comes

from one speaker only.

• Check the speaker connections. (→ page 2)

No sound or there is a

lot of noise.

• Noise may occur when playing MP3 if recording quality

is poor.

• Keep this unit away from mobile telephones.

• Turn the volume up.

• Switch off the unit, determine and correct the cause,

then switch the unit on. Causes include shorting of the

positive and negative speaker wires, straining of the

speakers through excessive volume or power, and

using the unit in a hot environment.

Humming heard during

play.

• An AC mains lead or fluorescent light is near the

cables. Keep other appliances and cords away from

this unit’s cables.

A beat sound is heard

while receiving a radio

broadcast.

• Turn the TV off or separate it from the unit.

A low hum or noise is

heard during AM

broadcasts.

• Keep the antenna away from other cables and cords.

• Keep the AM antenna away from the unit.

The picture on the

television near the set

disappears or stripes

appear on the screen.

• The location and orientation of the antenna are

incorrect.

• The TV antenna wire is too close to the unit. Separate

the antenna wire of the TV set from the unit.

Remote control

doesn’t work.

• Check that the battery is inserted correctly. (→ page 2)

• Replace the battery if it is worn.

– –:– –

• You plugged the AC adaptor in for the first time or there

was a power failure recently. Set the time. (→ page 5)

• The total programmed play time is more than 200

minutes.

Tracks can still be programmed and played.

PGM FULL

• The number of programmed tracks is limited to 24. No

further tracks can be programmed.

NOT MP3

• A non-CD-DA or non-MP3 CD-ROM disc is inserted.

Cannot be played.

ERROR

• Incorrect operation performed. Read the instructions

and try again.

F76 • There is a power supply problem. Consult the dealer.

Matsushita Electric Industrial Co., Ltd.

Web Site: http://www.panasonic.co.jp/global/

RQT7320-B

H0104ZZ0

GCS

E EB

SC-EN7 (RQT7320-B).fm 1 ページ２００４年１月２７日　火曜日　午前１１時４６分

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Troubleshooting guide

1Dear customerThank you for purchasing this product.Before connecting, operating or adjusting this product, please read theseinstructions completely.P

Seite 2 - Connections

2Use the numbers indicated in parentheses when asking forreplacement parts.Supplied accessories1 Remote control(EUR7711110)2 Batteries 1 AM loop anten

Seite 3 - CD operations

3CD operationsCLOCK/TIMER ADJSLEEPPGM/CLEARPLAY MODEui34TIMERSET/CHECK DISPLAY1234567809>=10AUXTUNER/BANDgCDq/hEXTRAD.BASS SOUNDEQLIVEVIRTUALIZERu

Seite 4 - Radio operations

4Radio stations can be turned manually by selecting the station’s frequency or they can be preset into channels to make it easy to tune.You can preset

Seite 5 - Timer and others

5Timer and othersCLOCK/TIMER ADJSLEEPPGM/CLEARPLAY MODEui34TIMERSET/CHECK DISPLAY1234567809>=10AUXTUNER/BANDgCDq/hEXTRAD.BASS SOUNDEQLIVEVIRTUALIZE

Seite 6 - Control guide

6 Standby/on switch [^]... 3Press to switch the unit from on to standby mode

Seite 7 - LASER PRODUCT

7Set the unit up on an even surface away from direct sunlight, hightemperatures, high humidity, and excessive vibration. These conditions candamage th

Seite 8 - Specifications

8(For continental Europe, the United Kingdom, Australia and New Zealand)(For other areas)SUOMINORSKTo clean this unit, wipe with a soft, dry cloth.• N